✦ LIBER ✦

A Study of the Measurement of Surface and Interfacial Tension by the Maximum Liquid Drop Volume Method: I. Using a Back-Suction Syringe Technique

✍ Scribed by Bingyin Pu; Donghao Chen

Publisher: Elsevier Science
Year: 2001
Tongue: English
Weight: 139 KB
Volume: 235
Category: Article
ISSN: 0021-9797
DOI: 10.1006/jcis.2000.7385

No coin nor oath required. For personal study only.

✦ Synopsis

The maximum liquid drop volume (nu(max)) is measured using a back-suction technique with a micrometer syringe piston. The residual amount of liquid on the tip was determined and the tension data calculated from the theoretical correction factors are well in accordance with those from the falling drop volume (nu(f)). Copyright 2001 Academic Press.

📜 SIMILAR VOLUMES

A Study of the Measurement of Surface an

A Study of the Measurement of Surface and Interfacial Tension by the Maximum Liquid Drop Volume Method: II. Viscosity Effect on the Tension Measurement

✍ Bingyin Pu; Donghao Chen 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 66 KB 👁 1 views

The maximum liquid drop volume (v(max)) is measured by using a back-suction micrometer syringe piston technique. Different very viscous liquids are measured by (v(max)) and (v(f)) methods to observe the effect of viscosity on tension measurement. No apparent viscosity effect was observed in surface

Measurement of the Surface and Interfaci

Measurement of the Surface and Interfacial Tension from Maximum Volume of a Pendant Drop

✍ Rok Gunde; Arun Kumar; Stefanie Lehnert-Batar; Roland Mäder; Erich J. Windhab 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 124 KB

Described herein is a two-phase nonempirical method for the determination of surface or interfacial tension of stationary systems that also allows the determination of drop correction factor. The method is based on the theoretical calculation of the drop profile associated with the maximum volume of