✦ LIBER ✦

A simulation model for analysis and design of continuous grinding mills

✍ Scribed by Csaba Mihálykó; Tibor Blickle; Béla G. Lakatos

Book ID: 114080198
Publisher: Elsevier Science
Year: 1998
Tongue: English
Weight: 530 KB
Volume: 97
Category: Article
ISSN: 0032-5910
DOI: 10.1016/s0032-5910(97)03396-2

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A model for continuous grinding in a lab

A model for continuous grinding in a laboratory hammer mill

✍ L.G. Austin; V.K. Jindal; C. Gotsis 📂 Article 📅 1979 🏛 Elsevier Science 🌐 English ⚖ 470 KB

A preliminary simulation model for fine

A preliminary simulation model for fine grinding in high speed hammer mills

✍ Leonard G. Austin 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 279 KB

Optimal control of a ball mill grinding

Optimal control of a ball mill grinding circuit—I. Grinding circuit modeling and dynamic simulation

✍ Raj K. Rajamani; John A. Herbst 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 1008 KB

A model for analysis and design of conti

A model for analysis and design of continuous grinding mills : C.Mihalyko et al. (University of Veszprem, Veszprem, Hungary.) Powder Technol., vol 97, no 1, 1998, 51–58

📂 Article 📅 1998 🏛 Elsevier Science 🌐 English ⚖ 320 KB

Determination of parameters for wet-grin

Determination of parameters for wet-grinding model in perl mills

✍ A. Heim; R. Leszczyniecki; K. Amanowicz 📂 Article 📅 1985 🏛 Elsevier Science 🌐 English ⚖ 455 KB

A solution to the distributed parameter

A solution to the distributed parameter model of a continuous grinding mill at steady state

✍ T.S. Mika 📂 Article 📅 1976 🏛 Elsevier Science 🌐 English ⚖ 623 KB

A distributed parameter model of an open-circuit size reduction device at steady state is considered. The model is applicable to tumbling or vibratory mills. Material transport is described in terms of a size-dependent axial convective velocity and a size-dependent axial dispersion coefficient. For