✦ LIBER ✦

A sensor for the detection of tool breakage in NC milling

✍ Scribed by Y.S. Tarng; B.Y. Lee

Book ID: 108027327
Publisher: Elsevier Science
Year: 1993
Tongue: English
Weight: 594 KB
Volume: 36
Category: Article
ISSN: 0924-0136
DOI: 10.1016/0924-0136(93)90034-4

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A new algorithm for the detection of too

A new algorithm for the detection of tool breakage in milling

✍ Jose C. Principe; Taehwan Yoon 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 657 KB

this paper a novel signal processing algorithm is presented for the detection of tool breakage using the displacement signal (RORPA). The algorithm extracts information from consecutive revolutions to decrease dependencies on runout conditions and idle noise, creating a much more robust signal for t

On-line detection of tool breakage in mi

On-line detection of tool breakage in milling

✍ Y.S. Tarng 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 622 KB

A multi-sensor strategy for tool failure

A multi-sensor strategy for tool failure detection in milling

✍ Di Yan; T.I. El-Wardany; M.A. Elbestawi 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 806 KB

Detection of tool breakage in milling op

Detection of tool breakage in milling operations—II. The neural network approach

✍ Ibrahim Nur Tansel; Charles McLaughlin 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 850 KB

Detection of tool breakage in milling op

Detection of tool breakage in milling operations—I. The time series analysis approach

✍ Ibrahim Nur Tansel; Charles McLaughlin 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 827 KB

Study of milling cutting force pulsation

Study of milling cutting force pulsation applied to the detection of tool breakage

✍ Y.S. Tarng 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 583 KB