✦ LIBER ✦

A review of abrasive jet machining

✍ Scribed by N. Ramachandran; N. Ramakrishnan

Publisher: Elsevier Science
Year: 1993
Tongue: English
Weight: 615 KB
Volume: 39
Category: Article
ISSN: 0924-0136
DOI: 10.1016/0924-0136(93)90005-q

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

An experimental study of abrasive jet ma

An experimental study of abrasive jet machining

✍ A.P. Verma; G.K. Lal 📂 Article 📅 1984 🏛 Elsevier Science ⚖ 695 KB

Abrasive jet machining of glass at low t

Abrasive jet machining of glass at low temperature

✍ M.K. Muju; A.K. Pathak 📂 Article 📅 1988 🏛 Elsevier Science ⚖ 280 KB

Performance of different abrasive materi

Performance of different abrasive materials during abrasive water jet machining of glass

✍ A.A. Khan; M.M. Haque 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 501 KB

Different types of abrasives are used in abrasive water-jet machining like garnet, aluminum oxide, olivine, silica sand, silicon carbide, etc. The present work gives a comparative analysis of the performance of garnet, aluminum oxide and silicon oxide during abrasive water-jet machining of glass. Th

An empirical study of parameters in abra

An empirical study of parameters in abrasive jet machining

✍ V.C. Venkatesh; T.N. Goh; K.H. Wong; M.J. Lim 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 643 KB

A study of abrasive water jet machining

A study of abrasive water jet machining process on glass/epoxy composite laminate

✍ M.A. Azmir; A.K. Ahsan 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 711 KB

Surface roughness (R a ) and kerf taper ratio (T R ) characteristics of an abrasive water jet machined surfaces of glass/epoxy composite laminate were studied. Taguchi's design of experiments and analysis of variance were used to determine the effect of machining parameters on R a and T R . Hydrauli

Tribology of abrasive machining

✍ A.G. King 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 654 KB