✦ LIBER ✦

A positron study of a fine-grained Zn-Al-Mg alloy

✍ Scribed by C. Hidalgo; N. de Diego; M.A. Ochando

Publisher: Elsevier Science
Year: 1984
Tongue: English
Weight: 150 KB
Volume: 49
Category: Article
ISSN: 0038-1098
DOI: 10.1016/0038-1098(84)90203-5

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Production of Very Fine Grained Mg–3%Al–

Production of Very Fine Grained Mg–3%Al–1%Zn Alloy by Continuous Extrusion Forming (CONFORM)

✍ Youliang He; Fei Gao; Baoyun Song; Jian Li; Rong Fu; Guiming Wu 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 661 KB

Positron Lifetime Studies of Decompositi

Positron Lifetime Studies of Decomposition in Engineering and Laboratory 2024 (Al–Cu–Mg) and 7075 (Al–Zn–Cu–Mg) Alloys

✍ Dlubek, G. ;Krause, H. ;Krause, S. ;Unger, R. ;Heyroth, W. 📂 Article 📅 1998 🏛 John Wiley and Sons 🌐 English ⚖ 106 KB 👁 1 views

High-temperature behavior of a cryomille

High-temperature behavior of a cryomilled ultrafine-grained Al–7.5% Mg alloy

✍ Bing Q. Han; Enrique J. Lavernia 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 370 KB

A study of hydrostatic extrusion as a co

A study of hydrostatic extrusion as a consolidation process for fabricating ultrafine-grained bulk Al–Mg alloy

✍ S. Lee; C.Y. Yoon; H.J. Park; S.S. Kim; E.J. Kim; T.H. Choi; K.Y. Rhee 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 641 KB

This paper deals with the hydrostatic extrusion process for fabricating an ultrafine-grained bulk Al-Mg alloy. Pre-hipped Al-7.5%Mg alloy was subjected to hot hydrostatic extrusion in order to investigate the potential use of this process as a final consolidation in fabricating the ultrafinegrained

Mechanical behavior of bulk ultra-fine-g

Mechanical behavior of bulk ultra-fine-grained Zn–Al die-casting alloys

✍ J.M. Gobien; R.O. Scattergood; F.E. Goodwin; C.C. Koch 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 831 KB

The mechanical properties of Zn-4 wt% Al casting alloys are compared after various processing methods including sand casting, die-casting, and high energy cryogenic ball milling. For the cast structures there is an increase in strength when transitioning from a coarse sand casting microstructure to

Production of ultra-fine grain microstru

Production of ultra-fine grain microstructures in Al–Mg alloys by coventional rolling

✍ A Gholinia; F.J Humphreys; P.B Prangnell 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 849 KB