✦ LIBER ✦

A new method for continuous casting of particulate reinforced metal matrix composite wires

✍ Scribed by H. Soda; Q. Xia; A. McLean; A.K. Pramanick; G. Motoyasu

Publisher: Elsevier Science
Year: 1996
Tongue: English
Weight: 923 KB
Volume: 216
Category: Article
ISSN: 0921-5093
DOI: 10.1016/0921-5093(96)10389-0

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A new method for bonding metal matrix co

A new method for bonding metal matrix composite inserts during casting

✍ S.A. Gedeon; I. Tangerini 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 754 KB

A new method, termed cast welding, has been developed for metallurgically bonding inserts into a cast component during a normal casting operation. This circumvents problems associated with squeeze casting or infiltrating a final component; composite inserts can be made previously, the component size

Behavior of Stir-Cast Al-Alloy Particula

Behavior of Stir-Cast Al-Alloy Particulate-Reinforced Metal-Matrix Composites under Successive Hot Rolling

✍ M.A. Taha; N.A. El-Mahallawy; A.M. El-Sabbagh 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 466 KB

Effect of pressure rolling on the residu

Effect of pressure rolling on the residual stress state of a particulate-reinforced metal matrix composite

✍ Eric Hanus; Torsten Ericsson 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 965 KB

Determination of the matrix in situ flow

Determination of the matrix in situ flow stress of a continuous fibre reinforced metal matrix composite using instrumented indentation

✍ J.L Bucaille; A Rossoll; B Moser; S Stauss; J Michler 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 678 KB

Influence of four-point bending fatigue

Influence of four-point bending fatigue on the residual stress state of a pressure-rolled, particulate-reinforced metal matrix composite

✍ Eric Hanus; Torsten Ericsson 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 909 KB

Use of submicron diameter carbon filamen

Use of submicron diameter carbon filaments for reinforcement between continuous carbon fiber layers in a polymer-matrix composite

✍ Steven W. Hudnut; D.D.L. Chung 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 454 KB

The incorporation of 0.1-0.2 pm diameter carbon filaments (0.6 vol.%) between continuous carbon fiber (7 pm diameter, 56.5 vol.%) layers in an epoxy-matrix composite during composite fabrication was found under flexure to greatly increase transverse and longitudinal tan 6 values, increase the storag