๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

A near optimal crack tip mesh

โœ Scribed by Fernando C.M. Menandro; E.T. Moyer Jr; H. Liebowitz


Publisher
Elsevier Science
Year
1995
Tongue
English
Weight
404 KB
Volume
50
Category
Article
ISSN
0013-7944

No coin nor oath required. For personal study only.

โœฆ Synopsis


The near optimal crack tip mesh obtained by the authors in a previous paper is tested for a set of problems. The accuracy is maintained within the desired values. The direct displacement extrapolation method for SIF estimation is compared to the virtual crack extension. The methodology for crack tip mesh design discussed previously is validated.


๐Ÿ“œ SIMILAR VOLUMES


A methodology for crack tip mesh design
โœ Fernando C.M. Menandro; E.T. Moyer Jr; H. Liebowitz ๐Ÿ“‚ Article ๐Ÿ“… 1995 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 764 KB

A methodology for crack tip mesh design is developed which consists of comparing the mesh geometric parameters against the accuracy of the finite element solution. By successive changes in the mesh parameters a near optimal mesh can be obtained. This was done here for two-dimensional linear elastic

Large deformations near a propagating cr
โœ J.D. Achenbach; N. Nishimura ๐Ÿ“‚ Article ๐Ÿ“… 1986 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 993 KB

The combined effects of large deformation and material inertia on the displacement gradients are analyzed for rapid mode III crack propagation. The constitutive model is linear at small strains, but the stress level cannot increase beyond a critical level. Steady-state dynamic strain fields are pres

Plane strain deformations of locking mat
โœ C.Q. Ru; R.C. Batra ๐Ÿ“‚ Article ๐Ÿ“… 1994 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 524 KB

Plane-strain deformations of an isotropic and homogeneous Hookean body containing a crack are studied and it is required that the dilatation everywhere in the body be. greater than or equal to a constant. Following Prager, the region where the dilatation always equals the constant is identified as t