✦ LIBER ✦

A modified point contact tire model for the simulation of vehicle ride quality

✍ Scribed by Qiu Xiding; Liu Jude; Men Yongxin

Publisher: Elsevier Science
Year: 1993
Tongue: English
Weight: 336 KB
Volume: 30
Category: Article
ISSN: 0022-4898
DOI: 10.1016/0022-4898(93)90001-e

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A simulation model for the prediction of

A simulation model for the prediction of the ground pressure distribution under tracked vehicles

✍ J.K. Gigler; S.M. Ward 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 447 KB

A computationally inexpensive modificati

A computationally inexpensive modification of the point dipole electrostatic polarization model for molecular simulations

✍ George A. Kaminski; Richard A. Friesner; Ruhong Zhou 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 117 KB

## Abstract We present an approximation, which allows reduction of computational resources needed to explicitly incorporate electrostatic polarization into molecular simulations utilizing empirical force fields. The proposed method is employed to compute three‐body energies of molecular complexes w

A modified model for simulating latent h

A modified model for simulating latent hardening during the plastic deformation of rate-dependent FCC polycrystals

✍ Y. Zhou; K.W. Neale; L.S. Tóth 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 1010 KB

A strain hardening model for the plastic deformation of rate-dependent FCC crystals is proposed based on experimental observations previously reported for single crystals. This model, which is an extension of that employed by PEmCE et al. [1983], includes both the selfhardening and latent hardening

Simulation of a regression-model and PCA

Simulation of a regression-model and PCA based searching method developed for setting the robust injection molding parameters of multi-quality characteristics

✍ M.-S. Huang; T.-Y. Lin 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 463 KB

This article proposes an advanced searching method for setting the robust process parameters for injection molding based on the principal component analysis (PCA) and a regression model-based searching method. This method could effectively reduce the influence of environmental noise on molded parts'