## Abstract This Letter presents a well‐suited model for the analysis of longitudinal‐slot dielectric‐filled waveguide antennas by extending the transmission‐line model used for printed slot antennas. The found slot admittance is calculated on the waveguide plane thanks to a transformation ratio th
A model for slot-coupled nonradiative dielectric waveguide and microstrip line
✍ Scribed by Davidovitz, Marat
- Publisher
- John Wiley and Sons
- Year
- 1997
- Tongue
- English
- Weight
- 210 KB
- Volume
- 7
- Category
- Article
- ISSN
- 1050-1827
No coin nor oath required. For personal study only.
📜 SIMILAR VOLUMES
## Abstract This paper presents an extension of the so‐called transmission line model method (TLMM) applied to shaped slot dielectric‐filled waveguide antennas (SDFWAs), especially the L‐shaped slot. This radiating longitudinal slot is fed by a transversal slot used as a coupling element; their ass
are somewhat reduced. For cases where thin substrates are used, these errors will be more pronounced. ## III. CONCLUSIONS A novel shorted patch configuration has been designed, constructed, and tested. The new technique has greater bandwidth and is easier to manufacture than the traditional short
## Abstract The single‐layer reduction (SLR) formulation is presented to compute the dielectric loss of even–odd modes of a multilayer coupled microstrip line. Results are compared against the results of full‐wave analysis with a maximum deviation of 2% for the wide range of parameters. © 2001 John
## Abstract Shorted square‐ring slot antennas with a rectangular slot are presented for the global positioning system (GPS) and third‐generation communication (3G) operations.The shorted square‐ring slot antenna is used as the basic configuration for circular polarization in the GPS band. Then, an