✦ LIBER ✦

A Model for Flow Bypass and Tip Leakage in Pin Fin Heat Sinks

✍ Scribed by Dogruoz, M. Baris; Ortega, Alfonso; Westphal, Russell V.

Book ID: 120824130
Publisher: The American Society of Mechanical Engineers
Year: 2005
Tongue: English
Weight: 927 KB
Volume: 128
Category: Article
ISSN: 1043-7398
DOI: 10.1115/1.2159009

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Optimization of Pin-Fin Heat Sinks in By

Optimization of Pin-Fin Heat Sinks in Bypass Flow Using Entropy Generation Minimization Method

✍ Khan, W. A.; Culham, J. R.; Yovanovich, M. M. 📂 Article 📅 2008 🏛 The American Society of Mechanical Engineers 🌐 English ⚖ 180 KB

Modeling of the thermal and hydraulic pe

Modeling of the thermal and hydraulic performance of plate fin, strip fin, and pin fin heat sinks-influence of flow bypass

✍ Jonsson, H.; Moshfegh, B. 📂 Article 📅 2001 🏛 IEEE 🌐 English ⚖ 228 KB

A semi-empirical model for estimating pe

A semi-empirical model for estimating permeability and inertial coefficient of pin-fin heat sinks

✍ Tzer-Ming Jeng; Sheng-Chung Tzeng 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 277 KB

Experimental study on liquid flow and he

Experimental study on liquid flow and heat transfer in micro square pin fin heat sink

✍ Minghou Liu; Dong Liu; Sheng Xu; Yiliang Chen 📂 Article 📅 2011 🏛 Elsevier Science 🌐 English ⚖ 839 KB

Investigation of flow and heat transfer

Investigation of flow and heat transfer characteristics in micro pin fin heat sink with nanofluid

✍ Hasan, Mushtaq Ismael 📂 Article 📅 2014 🏛 Elsevier Science 🌐 English ⚖ 110 KB

Flow visualizations and heat transfer me

Flow visualizations and heat transfer measurements for a rotating pin-fin heat sink with a circular impinging jet

✍ Tzer-Ming Jeng; Sheng-Chung Tzeng; Hong-Ru Liao 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 592 KB

This work experimentally investigated the fluid flow and heat transfer behaviors of jet impingement onto the rotating heat sink. Air was used as impinging coolant, while the square heat sinks with uniformly inline arranged 5 Â 5 and 9 Â 9 pin-fins were employed. The side length (L) of the heat sink