## Abstract In this article, we propose a new compact defected ground structure (DGS) bandstop filter with broad pass‐band, low insertion loss in the stop‐band, and sharp transition from pass‐ to stop‐band. The bandstop filter structure is simple as it is composed of a pair of octagonal DGS slots a
A miniaturized wideband coupled-line microstrip balun using a new defected ground
✍ Scribed by Cheng-Nan Chiu; Shau-Jiun Yu
- Publisher
- John Wiley and Sons
- Year
- 2011
- Tongue
- English
- Weight
- 647 KB
- Volume
- 54
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
This letter proposes a new miniaturized wideband coupled‐line microstrip balun and its design procedure based on an original finding. This finding suggests that the coupled‐line microstrip balun can be realized by using a much smaller high‐pass ground defect instead of a bandstop ground defect. The newly proposed balun is derived initially from a coupled‐line microstrip balun with a typical dumbbell‐shaped defected ground. Following the proposed three‐step design procedure, the size of the final balun is only about 8.3% of the size of the initial one (only 0.00512 wavelength square at the central frequency). In addition, the final balun possesses immunity against the influence of the supporting material. Balun prototypes were created and investigated. Both the simulated and measured results demonstrate the compactness and wideband performance. © 2011 Wiley Periodicals, Inc. Microwave Opt Technol Lett 54:254–257, 2012; View this article online at wileyonlinelibrary.com. DOI 10.1002/mop.26518
📜 SIMILAR VOLUMES
## Abstract In this article, a miniaturized parallel‐coupled microstrip filter is presented. The miniaturized design saves 80% circuit dimension compared to the conventional parallel‐coupled over‐coupled end stages filter with the symmetrical tapped‐line structure. Several design methods and miniat
## Abstract The introduction of defected ground structures (DGSs) in microwave bandpass filters, based on microstrip coupled‐ring resonators to suppress higher harmonics, is investigated. Two topologies based on placing DGS units into and out of the coupled rings are considered and investigated. Ha
## Abstract A miniaturized dual‐band Wilkinson power divider is designed and proposed using coupled transmission lines. The main part of the component consists of a microstrip hairpin resonator, which is implemented in a way to provide an artificial inductor and a capacitor between the two output p
## Abstract A wideband bandpass filter using parallel‐coupled‐lines with periodical grooves is presented in this article. Owing to the slow wave effect brought by periodical grooves, the proposed structure's resonant frequency can be lowered effectively. This effect has been used in this article to
## Abstract This letter reports a new design of compact end‐coupled microstrip bandpass filter with two arrowhead slots as defected ground structure (DGS) in the ground plane [Boutejdar etal., IEEE AP‐SSymp (2005); Ahn, IEEE Trans Microwave Theory Tech 27 (1979), 44–50; Won etal., IEEE Trans Microw