✦ LIBER ✦

A finite element study of the short beam test specimen under mode II loading

✍ Scribed by J. Watkins; K.L.W. Liu

Publisher: Elsevier Science
Year: 1985
Weight: 604 KB
Volume: 7
Category: Article
ISSN: 0262-5075
DOI: 10.1016/0262-5075(85)90025-9

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A finite element investigation of the ef

A finite element investigation of the effect of crack tip constraint on hole growth under mode i and mixed mode loading

✍ Y.Arun Roy; R. Narasimhan 📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 648 KB

In this work\ the e}ect of constraint on hole growth near a notch tip in a ductile material under mode I and mixed mode loading "involving modes I and II# is investigated[ To this end\ a 1!D plane strain\ modi\_ed boundary layer formulation is employed in which the mixed mode elastic KÐT \_eld is pr

Poroelastic behaviour of cortical bone u

Poroelastic behaviour of cortical bone under harmonic axial loading: A finite element study at the osteonal scale

✍ Vu-Hieu Nguyen; Thibault Lemaire; Salah Naili 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 914 KB

Bone fluid flow and its induced effects on the bone cells are important players in triggering and signalling bone formation and bone remodelling. This study aims to numerically investigate the behaviour of interstitial fluid flows in cortical bone under axial cyclic harmonic loads that mimics in viv

BIOMECHACAL ANALYSIS OF THE LUMBOSACRAL

BIOMECHACAL ANALYSIS OF THE LUMBOSACRAL SPINE UNDER VARIOUS LOADINGS AND GESTURES –A THREE-DIMENSIONAL FINITE ELEMENT STUDY

✍ H-T Hu; R-M Lin; C-S Kuo; P-C Lin; K-Y Huang 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 139 KB

The influence of support conditions in t

The influence of support conditions in the loading fixture on failure mechanisms in the push-out test: A finite element study

✍ Dr. T. P. Harrigan; J. Kareh; W. H. Harris 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 647 KB

## Abstract The usefulness of the push‐out test as an indicator of interface strength was evaluated using finite element models of intact and partially failed cylindrical push‐out specimens loaded against a rigid annular support. The irregular stress distributions that were found in intact specimen