Abstract
The effects of incorporation of three different fillers, i.e., rice husk ash (RHA), silica, and calcium carbonate (CaCO~3~), over a loading range of 0–60 phr on the curing characteristics, processability, mechanical properties, and morphology of 75 : 25 natural rubber (NR)/ethylene‐propylene‐diene monomer (EPDM) blends were studied using a conventional vulcanization system. Filler loading and type influence the processability of the blends in which RHA and CaCO~3~ offer better processing advantage over silica. The best improvement in the tensile and tear strength and abrasion resistance of the 75 : 25 NR/EPDM blends with additional fillers was achieved when filled with silica. However, RHA and CaCO~3~ were better in resilience property compared to that of silica. The RHA filled blends showed higher failure properties and abrasion resistance but lower ozone resistance than that containing CaCO~3~. Scanning electron micrographs revealed that the morphology of the blend filled with silica is finer and more homogenous compared to the blend filled with RHA and CaCO~3~. According to these observations, RHA can be used as a cheaper filler to replace CaCO~3~ in rubber blends where improved mechanical properties are not so critical. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008