## Abstract In this letter, a compact and high selectivity dual‐band dual‐mode microstrip bandpass filter (BPF) with the source‐load coupling is proposed using the single short‐circuited stub‐loaded stepped‐impedance resonator.The resonator can generate two resonant modes in each band. The short‐ci
A compact and low-loss LTCC diplexer with high-band selectivity and high isolation for dual-band applications
✍ Scribed by Tae Wan Kim; Young Chul Lee
- Publisher
- John Wiley and Sons
- Year
- 2010
- Tongue
- English
- Weight
- 231 KB
- Volume
- 52
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
This article presents a compact and low‐loss diplexer for dual‐band applications using a LTCC (low temperature co‐fired ceramic) multilayer technology. This diplexer is composed of the high‐pass filter (HPF) and low‐pass filter (LPF) in order to separate GSM (global system for mobile) and CDMA (code division multiple access) band. For enhancing band selectivity of the diplexer, a shunt capacitor and inductor are designed in the HPF and LPF, respectively. In addition, a transmission zero is designed at the stopband of the LPF using a shunt inductor for improving isolation characteristics. The diplexer is realized in a 6‐layer LTCC substrate with a relative dielectric constant of 7. The size of the fabricated diplexer including CPW pads is 3.45 × 4.0 × 0.7 mm^3^. A measured insertion loss (IL) and return loss (RL) of the GSM band are less than −0.54 dB and −10.50 dB, respectively. In the case of CDMA band, the IL of −1.13 dB and RL of below −6.16 dB are archived. © 2010 Wiley Periodicals, Inc. Microwave Opt Technol Lett 52: 1134–1137, 2010; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.25137
📜 SIMILAR VOLUMES
## Abstract In this letter, a novel compact wideband bandpass filter (BPF) using single asymmetric stepped‐impedance resonator with one‐step discontinuity is designed and fabricated. The first two resonant modes of the asymmetric SIR are coupled together and applied to create a wide passband. The p
In this letter, the numerical and analytical characteristic modes for perfectly conducting, elliptic cylinders are formally deri¨ed, and a comparison between them is presented. A good agreement between numerical and analytical solutions is obser¨ed. The analytical solution of the TM scattering from
## Abstract This paper presents a compact X‐band, 9 W AlGaAs/InGaAs/GaAs PHEMT MMIC high power amplifier. This amplifier is designed to fully match a 50 Ω input and output impedance. Based on 0.35 μm gate‐length power PHEMT technology, a two‐stage power amplifier is fabricated on a 3‐mil thick wafe