A Class of Semi-Active Suspension Schemes for Vehicle Vibration Control
β Scribed by F. Oueslati; S. Sankar
- Publisher
- Elsevier Science
- Year
- 1994
- Tongue
- English
- Weight
- 524 KB
- Volume
- 172
- Category
- Article
- ISSN
- 0022-460X
No coin nor oath required. For personal study only.
β¦ Synopsis
As a compromise between passive and active suspensions, a semi-active (SA) suspension scheme is suggested and demonstrated for both 1- and 4-degree-of-freedom (DOF) vehicle models. Because only limited number of vehicle aspects can be studied using a 1-DOF model, a more comprehensive 4-DOF model is suggested, based on an optimal active suspension strategy. For this purpose, a fully active fail safe suspension is developed for the 4-DOF model using the optimal regulator theory. Rood mean square (r.m.s.) bounce and pitch absolute acceleration transmissibility plots of the sprung mass and plots of maximum suspension and tire deflections are presented for SA suspensions, and compared with passive and active schemes.
π SIMILAR VOLUMES
Both theoretical and experimental investigations are performed for a scheme for ''flutter taming''-semi-active control of structural non-linear flutter. For a two-dimensional non-linear flutter system, a digital simulation method is used to verify the principle of semi-active flutter control and to
A semi-active controller for excessive transient vibrations of resonant flexible structures is presented. The suggested controller technique is based upon using an impact damper with a variable clearance. Numerical simulations were employed to investigate the design parameters. Simple experiments we
This paper describes a procedure to improve the behavior of a light allterrain military vehicle moving, over rough ground and large obstacles, at high speed. This improvement has governed the choice of a new concept of hydraulic activeΒ±passive linking between the body and the ground. A hierarchical
The potential bene"ts of a semi-active magnetorheological (MR) damper in reducing the incidence and severity of end-stop impacts of a low natural frequency suspension seat are investigated. The MR damper considered is a commercially developed product, referred to as &&Motion Master semi-active dampi
Multiple model adaptive control schemes offer the potential of improved performance over conventional single model schemes in a number of cases of practical interest. This paper describes modifications to enhance the performance of one class of such schemes when applied to linear and (potentially) n