No coin nor oath required. For personal study only.
Effect of coal preoxidation on the development of microporosity in activated carbons P;trra. .I B. ('t ul.. C01%)0)1. lY9h. 34, (h), 7X3-787. This paper looks at the preparation of activated carbons from a \emtanthracite preoxldized in air to different degrees. The activation was carried out in steam at X50 to SO f I% burnoff. The adsorption isotherms of nitrogen at 77 K and carbon dioxide at 273 K were given. The adsorption isotherms indicate th:lt the activated carbons obtained from non-oxidized coal have poor portrsity, hut the porosity increased with increase in the degree of coal preoxidation. The BET surface area increase\ from lht) m'/p in the cast of activated carbon from oxidized coal char. The result5 give t-plot\ that show that the degree of oxidation enhances both small and medium microporosity, the increase in small microporosity being much larger. The activated carbons obtained from preoxidizcd coal chars are Iargcly microporous in character. 97100077 Energy-chemical coal processing. 2. Influence of coal quality on the yield of target products and energy efficiency of coal conversion to coke, methanol, heat and energy through intermediate gasification Gudkov. A. V. ('I cl/.. Clrcsr~. Su,srcrirtcrhlc Detr., IYYh, 4. (I ). 50-64.
This paper focuser on the influence of chemical composltion of raw coal% on thclr complex prtrcccsing to methanol, coke. heat. electricity through gasification.
97lOOO78
The flood/drain bioreactor for coal and mineral processing Andrew, (i. F. and Noah, K.
📜 SIMILAR VOLUMES
liquefied waste tyre served as a solvent for coal and was coprocessed with coal under reaction conditions that were favourable for liquefying coal and upgrading coal liquids ## 97101816 Use of dispersed catalysts for direct coal liquefaction
02 Liquid fuels (derived liquid fuels) were prepared by adding suitable dispersants and emulsifiers. Conductivity measurement was used to distinguish the type of OCWF. The influences of ratio of components and nature of surfactants on the rheological properties and stability of OCWF were investigat
A processing route involving low temperature carbonization followed by dry magnetic separation is put forward for the desulfurization and deashing of typical low-rank lignitic coals. The 23 mm lignite samples were subjected to low temperature carbonization at 6008C for 15 min and then upgraded by ma
01 Solid fuels {preparation) dichloromethane and the average molecular weight of the extracts were detected. The degree of conversion of the coals studied to the products solubility in dichloromethane was found to be surprisingly high regarding the low-rank coals. This paper puts forward an hypothes