148. Pyrolytic analysis of carbon fibers
โ Scribed by J.S Perkins; D.S Smith; D Rivin
- Publisher
- Elsevier Science
- Year
- 1973
- Tongue
- English
- Weight
- 129 KB
- Volume
- 11
- Category
- Article
- ISSN
- 0008-6223
No coin nor oath required. For personal study only.
โฆ Synopsis
ABSTRACTS and addition of graphitized pitch produced the low thermal expansion coefficient characteristic of stress relief without filament failure, and had the highest tensile and shear strengths among several 7-D materials tested. 143. Restrained thermal expansion bebavior of ATJS and some carbon fi~r/py~~n matrix composites* B. L. Butler and J. C. Tidmore (Sanka Laboratories, Albuquerque, New Mexico). The stress generated by restrained thermal expansion of some carbon-carbon composites and ATJ-S has shown that stress relaxation can occur when the material processing temperature is exceeded. The stress relaxation was accompanied by permanent material strain which is indicative of plastic deformation. Thus the thermal response of reentry materials may be time-and temperature-dependent and should be treated accordingly.
๐ SIMILAR VOLUMES
Data on short-time high-temperature tensile creep parallel to the substrate for two pyrolytic carbons (pyrolytic graphites) characterized by their microstructures as substrate nucleated (SN) and regeneratively nucleated (RN) h ave been analyzed by means of the Dom method.(i) Over the range of approx
Ah&a&--At arc discharge in a methane ambient, the heat-up of the anodic and cathodic patches can under certain conditions be high enough to initiate gas pyrolysis. Then carbon deposits grow onto the electrodes within the patches. The anodic deposits have a column shape, while the cathodic deposits a